The production line is available for one-step completion of slides roll forming, ball cage production, assembling, riveting and end bending with high efficiency, high accuracy, well stability and long service life.
Step 1: Outer / Middle / Inner Slides Roll Forming (Material Coil – Decoiling – Feeding – Roll Forming – Straightening – Punching & Cut-Off).
Step 2: Ball Cage Production (Motor Decoiling – Feeding – Punching & Cutting).
Step 3: Auto Ball Assembling (Middle Slide, Ball Cage & Steel Balls; And Adding Grease).
Step 4: Manually Assemble Middle Slide Stopper.
Step 5: Outer Slide Oiling (Adding Lubricant Grease).
Step 6: Inner Slide Riveting (Inner Slide & Rivet & Plastic Lock).
Step 7: Ball Pressing (Plastic Strip & Steel Balls).
Step 8: Manual Assembling (Outer & Middle & Inner Slides & Plastic Strips).
Step 9: QC Adjusting (Check Slide’s Smoothness For Loosing Or Tightening).
Step 10: Outer Slide End Bending & Fit End Rubber.
Step 11: Finished Drawer Slides For Packing.
1. Roll Forming Machine, 3 Units
2. Ball Cage Production Line, 1 Unit
3. Auto Ball Assembling Device, 1 Set
4. Outer Slide Oiling Device, 1 Set
5. Ball Pressing Machine, 1 Set
6. Riveting Machine, 1 Set
7. End Bending Power Press, 1 Set
8. Hand Adjuster, 3 Sets
There are full auto drawer slide machine production line as well.
1. Material: CR / SS Steel Coil.
2. Profile Size: 1.2×1.2×1.5 MM; 45#; Customization Available (38#/53#/78#, etc.).
3. Profile Length: 10’’, 12’’, 14”, 16”, 18”, 20”, 22”, 24” (250 – 600 MM; 8 Lengths).
4. Productivity: 3500 Pairs / 8 Hours.
5. Plant Area Required: 200 M2 (Minimum)
6. Labor Required: 7-20 Workers (Max.); Depends On The Production Demands.
